PUNCHING MACHINE
PRECISION SERVO-PRESS
SERVO-PRESS UNIT
RGS05005 / RGS05010
Best design with accuracy and power ability.
Standard specification
*inside() is RGS05010 specification
| Maximum pressure | 5kN *1 |
| Sensor stroke | 50mm(100mm) |
| Machine stroke | 80mm(130mm) |
| Motor static feeding speed | 125mm/sec. |
| Motor input capacity | 400W･3000r/min. |
| Post material | SUJ-2 or SKS-3 |
| Guide housing material | FC Electroless Nickel |
| Case, Color | equivalent of Mansel color 7.5Y9/1 |
Designing condition
*Inside() is RGS05010 specification
| Continuous pressure | 2kN |
| Pressurizing stroke | 5mm |
| Pressurizing feeding speed | 10mm/sec. |
| Cycle stroke | 50mm(100mm) |
| Fast forward speed | 125mm/sec. |
| Post end fixture weight | 5kgf |
| Set up cycle | 30spm(20spm) |
- *High frequency and stopping with pressure for long hours should be avoided due to motor static torque might be over the limit at the maximum pressure. Also please select the suitable torque limit capacity of motor.
- Machine stroke means the stroke restricted by mechanically, not effective stroke. Application is used under machine stroke.
- otor static feeding speed means maximum speed at 3000r/pm, not maximum feeding speed.
- Three sensors are bottom dead centre, origin and top dead center. Without sensor is possible. However safety devices are required.
- Design condition means condition which used during development, not maximum number. Please contact us if you required high accuracy, heavy load, and long hours pressing than above design condition.
- The motor is not included with this item. Please confirm the installation hole size which are different in each manufactures.
- The load could be over by load weight, when stop hours is long. We suggest turning off or control by break.
- The small error might be occurred depending on control devise or motor. Also please set the correct gain number.
Go to top